Lube - Glide Clay Auto Finesse | Skoda-Parts.com

Lubricant that prevents scratching the paint during the cleaning process.

Auto Finesse Glide Clay Lube is an extremely smooth and gentle clay lubrication, also suitable for dilution.

Lack of proper "lubrication" is one of the causes of scratching the paint during the clay process. That's why they created the Glide Clay Bar Lube at Auto Finesse. Its special mixture helps to encapsulate the metal chips that are released during the clay process. Allows the Clay Bar effect to slide on the surface of the vehicle. This significantly reduces the chance of scratches during the entire decontamination of the car.

The Auto Finesse Glide was formulated primarily to work in conjunction with the Auto Finesse Clay Bar. Its special blend of long-life lubricant allows the clay to glide over the lacquer surface with ease, like a well-oiled ball bearing. Once you are done with the clay process, the microfiber towel must slide down from the surface by itself. In the event that the microfiber towel gets stuck somewhere, it will reveal a contaminated area. This way you can easily detect shortcomings and save time you can spend on another detailing phase.

Glide for working with fine clay can be diluted in a ratio of up to 1: 5. There is no need to rinse after work and it is practically enough to finish the car with a microfiber cloth.

Application procedure:
1) Tear off a small piece of clay and mash it on a patty
2) Either dilute the Glide in a mixing bottle or leave it in the concentrate
3) Spray Glide on an area of ​​approx. 40x40 cm
4) Slide the clay on the surface in vertical and then horizontal movements
5) Once the decontaminated area is clean, wipe off the remaining lubricant with a soft cloth and go to the next section.

Note: The degree of dilution of the lubricant depends on the degree of soiling, the hardness of the paint and, last but not least, the hardness of the clay used. If you use the Clay Bar from Auto Finesse, you can dilute up to a ratio of 1:10 in the case of routine maintenance. For heavy soiling, we recommend a maximum dilution of 1: 5. Using hard clay from any manufacturer, leave the lubricant in the concentrate or dilute the maximum in a ratio of 1: 1. In the case of medium-hard clay, dilute in ratios of 1: 2 to 1: 5 according to the degree of contamination. For soft clays, you can dilute in the same way as for the Auto Finesse Caly bar, ie up to a ratio of 1:10. If you are performing decontamination on soft varnishes, do not dilute the lubricant for safety.